by vnmarket | Jun 10, 2026
1. How to reset the speaker ruler Problem: When closing the mold, the machine reports an error indicating that the guide ruler is in the wrong position. On-screen operations: On the home screen, press F10 , then press F3 to enter the system settings page. Enter...
by vnmarket | Jun 10, 2026
There are five main reasons why glue cannot be dispensed, along with specific troubleshooting steps. 1. The safety door is not closed. Problem: The machine displays an error message during spraying if the door is not completely closed. Troubleshooting: Close the...
by vnmarket | Jun 10, 2026
There are six main causes and corresponding solutions as follows: 1. The safety door is not closed. Problem: The machine displays an error message on the screen during the material loading process. Procedure: Check and completely close the safety door before loading....
by vnmarket | Jun 10, 2026
1. Remove and inspect the control board. Open the electrical cabinet: Open the protective box and disconnect the signal connectors attached to the AK668 (or equivalent) circuit board. Cleaning: Use a brush and compressed air to remove dust and dirt from the circuit...
by vnmarket | Jun 10, 2026
1. Maintain the mold and clamping system. Moldless machine: Clean the jaw surface thoroughly and apply anti-rust oil to protect the metal surface. The machine is currently clamped: Clean the mold and perform mold closing at low pressure (do not use high pressure)....
