1. Prepare the components.
The parts that need to be prepared include:
-
Screw and Barrel.
-
Screw tip, collar seat, screw collar.
-
Nozzle, Front Barrel.
-
Hexagon bolts, hexagon plugs, and heat-resistant grease.
2. Install the three-piece screw head assembly.
-
Assembly order: Assemble the push ring, retaining ring, and screw head together.
-
Important note: The collar seat must be installed correctly to ensure a tight seal and prevent backflow. There are two standards: standard (angled) and flat, depending on the type of machine.
3. Install the screw input assembly.
-
Apply heat-resistant grease to the threads of the screw head.
-
Screw the head assembly onto the screw shaft counterclockwise and tighten with a specialized wrench.
4. Install the auxiliary parts on the puller barrel.
-
Wrap heat-resistant Teflon tape around the hexagonal plugs and insert them into the holes on the puller barrel.
-
Clean the contact surfaces between the drumstick and the drumstick cutting board thoroughly.
-
Apply high-temperature grease to all flange tightening bolts.
5. Install the front barrel.
-
Attach the puller chuck plate to the puller head and tighten the bolts by hand first.
-
Tightening rule: Tighten bolts diagonally to ensure even pressure across the contact surfaces.
6. Completion
-
Insert the entire screw shaft, with the head attached, into the puller barrel from the rear end.
-
Apply heat-resistant grease and attach the nozzle to the puller barrel, then tighten it securely with a specialized wrench.
Adhering to the correct installation procedures and using heat-resistant grease will ensure stable machine operation and easy disassembly during subsequent maintenance.